This is a draft cheat sheet. It is a work in progress and is not finished yet.
Configure a WLAN
STEP 1: Log into the WLAN-Controller by surfing it's IP address and entering the login credentials |
STEP 2: Create a new WLAN by going into the WLAN tab and clicking NEW |
STEP 3: To enable the WLAN, edit the newly created WLAN and check the ENABLED Box |
Configure RADIUS
STEP 1: Under the Security tab open the RADIUS dropdown and click on Authentication |
STEP 2: Now enter the IP of the RADIUS Server and a Shared secret key |
Configure a WPA2 Enterprise WLAN
STEP 1: In the WLAN edit page you can select an Interface |
STEP 2: WLAN edit page --> Security tab --> enable AES and 802.1X |
STEP 2: WLAN edit page --> Security tab --> AAA Server* --> you can select a RADIUS server |
|
|
Definitions
SNMP: Simple Network Management Protocol, allows to monitor the network with log messages (traps) |
RADIUS: Remote Authentication Dial-In User Service, allows to authorize users going into the network |
Configure a new Interface
STEP 1: Controller tab --> Interface --> new |
STEP 2: It now allows you to enter an Interface name and a VLAN ID |
STEP 3: On the edit page the most important parts are the physical port and the Interface address and the DHCP Server |
|
|
Configure SNMP
STEP 1: Under the Management tab click on TRAP Receivers and click on NEW |
STEP 2: Now enter a name and the IP address of the SNMP Server |
Configure a DHCP Scope
STEP 1: Controller tab --> Internal DHCP Server dropdown --> DHCP Scope |
STEP 2: In the edit page, it allows to configure the Pool, network, default routers and the Status |
|